How do you get your motorcycle handlebars to stay tight when they are tightened as tight as they go? - tight
I recently put some 18 "ape hangers on my Harley and sometimes come loose a little when I hit a few bumps in the road. What is the best way to hold it? I've heard so much that the screws . Sitting
Tuesday, November 10, 2009
Tight How Do You Get Your Motorcycle Handlebars To Stay Tight When They Are Tightened As Tight As They Go?
Subscribe to:
Post Comments (Atom)
4 comments:
If node surface, raise the bar and back again. I saw the bars, and I can not imagine it would remain, regardless of how the ancient Chinese secret, you tried. Lock Tite help with bolts were loose.
Hello
They seem to) on a good size (diameter, probably because the size of the tube metric handlebars.Most PF
If you touched the right screw through the lower and upper clamping screw the bottom of the palette
The adaptation of certain thin plate around the handlebars to increase the diameter to be written in the brackets
If the screws do not live right around the bottom and are therefore a jump in the hole you cut a little, and you do not remove the screws and washers that the thickness necessary clamps to tighten and
Also, the use of Loctite or final adjustment as nail to stop the destruction of
Hope this helps
Andy C
Cycle Shop and white are right ... but I would like to add .....
1. Are the ranges on the bike? If so, you see the clip downwards in the riser / clamp gap. Are there areas in the holes on the front or back raised? If so, what the side that receives a first pair is ..... Loosen the side dish, pair side view, then the pair on the flat side. 12-18 ft / lbs torque is correct can, but handle strings and 18-22 to the 18 monkeys use it, not less than 18 is too vague.
2. His (preferably both stripes) of the bars or stripes? Without knots, this bar is not monkey ..... Node must be fixed!
3. One of the other suggestions ... How is the condition of the lift rubber pads? But rubber-share? If so ..... You really should replace it with polyurethane bushings .... All this must stop, bending and torsion bars ........ Gooden Tight Riser Bushing Kit ....
http://www.dragspecialties.com/fatbook/1 ...
Em Wrap paper around the glass 80 in the terminals.
You can also customize the terminals and drill a screw through the bars of sand paper, but the trick works well and can ..
Post a Comment